TY  - BOOK
AU  - Sultan, Ali (100427) 2014
TI  - Design and fabrication of biscuit assembly plant using pneumatic press
PY  - 2014///
CY  - Islamabad.
PB  - Department of Mechatronics Engineering (Air University Main Campus)
N1  - BEMTS
N2  - This project is the mechanical fabrication of biscuit assembling plant using pneumatic press and Arduino control. The major components of the project consist of two conveyors, one pneumatic injector and one pneumatic press. we use  DC Gear motor attached to the rounding table which will stop after 90 degree turn. The two conveyor belts which are used for the placing of biscuit on the rounding table. Then, by using injector we put down some specific amount of chocolate on the biscuit and second conveuor use for again placing the second biscuit on the first biscuit which already consist of chocolate At the end, pneumatic press will press the biscuit to make a firm product..These all systems of conveyor belts, Gear motor, injector and pneumatic press are controlled by the Arduino Mega 2560 and 24V dC gear motors used in conveyors and for rounding disc
ER  -